IFS-10 Fusion Splicer Troubleshooting Power supply • Power does not turn off when pressing ⊙: Press and hold the key until the LED color changes from green to red. • Few splices can be made with a fully charged battery pack: •If the power saving function is not enabled, battery power degrades faster. Refer to […]
Month: April 2015
How to splice fiber by Inno IFS-10 Fusion Splicer
How to splice fiber optic cable This section is a detailed introduction about how to splice two fibers together to become a single core fiber. the instruction divided into several section, please refer the list as follow: 1. Preparing the splicer 2. Preparing the fiber 3. How to make a splice 4. How to check […]
Loose Tube Vs. Ribbon Fiber Cabling
Making the Right Fiber Cable Choice can Improve Overall Performance of Distribution Cables in the PON In the distribution portion of the passive optical network (PON) for fiber-tothe-premise (FTTP) architectures, the choice of fiber cabling – ribbon vs. loose tube – can directly impact ease of installation and future performance. As is usually the case […]
Wavelength Division Multiplexing (WDM)
WDM Introduction WDM dramatically expands the total capacity of an optical network by enabling a large number of independent wavelength channels to travel within the same network. This core technology allows network capacity to be gradually and cost effectively increased while flexibly allowing multiple generations of transmission technologies to be supported on the same network […]
M2M Evolution Week in Review: IBM, Harris Poll, Konekt
It’s a short week here at M2M Evolution, but that doesn’t mean it hasn’t been exciting. We had lead stories on some amazing battery technology, a sweet IoT DIY Kickstarter campaign, bionic ants and an update on IBM’s $3 billion bet on M2M, to name just a few. Let’s start with the big dollar figure. […]
Comparison of LTE and WiMAX
1. Comparison of LTE Rel-8 and WiMAX 802.16e There are a lot of commonalities between LTE Rel-8 and WiMAX, but there are some notable differences. For example: LTE uses SC-FDMA for the uplink, whereas mobile WiMAX uses OFDMA. LTE user equipment (SC-FDMA) has a lower peak-to-average-power ratio when compared to mobile WiMAX user equipment (OFDMA), […]
M2M WORLD CONGRESS 2015
PROGRAMME 2015 London, UK, Europe. April 28-29, 2015. Day 1 & Day 2 (April 28th & 29th, 2015) 8:00 AM Registration 8:45 AM Welcome Remarks & Overview 9:00 AM Keynote I: How Internet of Things Will Disrupt Businesses and Industries David Parker, Global Vice President, SAP Internet of Things 9:20 AM Keynote II: M2M for […]
Wireless IoT Forum launches to accelerate development of the Internet of Things
The Wireless IoT Forum has launched to support and promote the deployment of the Internet of Things worldwide. The Forum has been created to drive the widespread adoption of wireless wide-area networking technologies in both licensed and unlicensed spectrum. It will work with key stakeholders from across the value chain to agree requirements that inform […]
What is M2M (Machine to Machine)
M2M Introduction Machine to machine (M2M) is a broad label that can be used to describe any technology that enables networked devices to exchange information and perform actions without the manual assistance of humans. In other terms: M2M refers to technologies that allow both wireless and wired systems to communicate with other devices of the […]
Fusion Splicer Error message list
Sumitomo Fusion Splicer Error Message List Please contact maintenance service center when it is not recovered if you take the measures below. Error message Description and measure Alignment Error (L)(R)(LR) [Description] There is dust in the V-groove. There is dust on the fiber. [Measure] Clean the V-groove. Re-cleave the fiber. Brightness Error Brightness Various Error […]