MTP I.B.C. Cleaner (MPO/MTP Connectors Only)

Use MTP I.B.C. P/N 7104 for either male or female connectors.
3.2.1 Open the dust cap lid on the MTP I.B.C. cleaner.
3.2.2 Insert the MPO/MTP connector into the dust cap.

3.2.3 Rotate the tape feeder wheel in the direction indicated on the cleaner.
3.2.4 Remove the connector from the cleaner tip. Close the dust cap lid
3.2.5 Inspect the endface with a 200X microscope. If contamination (oil, moisture, lint, etc.) is visible on any of the fiber tips, repeat the cleaning.
Continue until all fiber tips are clean.

Cleaning Connectors Installed In A Mating Adapter Or Transceiver
MTP I.B.C. Cleaner (MPO/MTP Connectors Only)
Use MTP I.B.C. P/N 7104 for either male or female MPO/MTP connectors.
4.1.1 Remove the external connector or dust cover (outside of the bulkhead, faceplate, or transceiver).
4.1.2 Remove the dust cap from the MTP I.B.C. cleaner.
4.1.3 Insert the cleaner into the adapter or transceiver.

NOTE: The MTP .I.B.C cleaner is keyed the same as a MPO/MTP connector. Insert the cleaner into the adapter or transceiver with the key of the cleaner matching the keyway of the adapter.
4.1.4 Rotate the tape feeder wheel in the direction indicated on the cleaner.
4.1.5 Remove the cleaner from the adapter or transceiver. Replace the dust cap onto the cleaner.
4.1.6 Inspect the ferrule tip with a 200X microscope. If contamination (oil, moisture, lint, etc.) is visible on the ferrule tip, repeat the cleaning. Continue until the ferrule tip is clean.
4.1.7 Clean the external connector using section 3.0 above.
4.1.8 Reinstall the external connector into the bulkhead, faceplate, or transceiver