100G & 400G Data Center

CS Connector – The Next Generation of Data Centre Connectivity by Senko

FOWIKI.comComments Off on CS Connector – The Next Generation of Data Centre Connectivity by Senko
Share

Senko’s new CS connector is specifically designed for Data Centre 400G optimization. Intended to complement the form factor of the next generation of (OSFP/ QSFP-DD) transceiver modules, the CS connector meets the requirement for 2x100G/200G CWDM4 transceivers requiring two pairs of TX/RX. Customer benefits include:

  • 36 % reduction in size. Pitch is reduced to 3.8mm from LC standard of 6.25 mm resulting in 1.8 times higher patch panel density.
  • No fan-out required and easy breakout.
  • Meets TOSA/ROSA specifications.
  • Uses tried and trusted LC standard size 1.25m ferrule.
  • Pullpush Tab
FOWIKI.com
http://fowiki.com

Related Articles

100G & 400G TOPICS

Introduction to 100G QSFP28 Single Lambda Transceivers

FOWIKI.com

Introduction 100G Single Lambda transceivers were defined by 100G Lambda MSA (100G Lambda Multi-Source Agreement). The MSA 100G MSA uses 100G PAM4 optical signaling and encoding it is able to use 100Gb/s per channel to transmit from 2m up to 40KM via single-mode fiber. Advantages The traditional 100Gb/s optical standards such as 100GBASE LR4, 100GBASE […]

100G & 400G Data Center

40 Gigabit Duplex Fiber Solutions

FOWIKI.com

There’s been a lot of talk lately surrounding bidirectional 40 Gb/s duplex applications, or BiDi for short. Currently offered as a solution by Cisco®, BiDi runs over duplex OM3 or OM4 multimode fiber using QSFP modules and wavelength division multiplexing (WDM) technology. It features two 20 Gb/s channels, each transmitting and receiving simultaneously over two […]

Data Center

Why MPO/MTP Connector End Face Geometry is Important?

FOWIKI.com

End face geometry is an essential characteristic of repeatable and reliable optical fiber connections. Overall performance of fiber optic connectivity depends on the mechanical characteristics that control alignment and physical contact of the fiber cores. End face geometry parameters for MPO/MTP connectivity include: Angle of the polish – Horizontal or X axis (RX and GX) […]